Disque Frein Moto EBC MD6116D

EBC MX brake disc for offroad motorcycles. MADE IN UK.

 

The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses HPSR steel with a low carbon content, which has an 18% higher friction coefficient. This steel is significantly more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which is braked in the area of ​​the brake lining contact zone when braking. It is only in this area that it is easier to form rust rust with a longer service life.

 

The brake discs are drilled in the bird’s swing signal to get rid of the rainwater and brake dust with as few holes as possible while simultaneously cleaning the brake disc. The fewer drill holes are installed, the better the wet braking behavior and the lower the wear.

 

– Rigid brake disc.

– Made from heat-treated carbon steel.

– Braked surface with optimized hole pattern.

– Radially ground.

– Galvanized to protect against corrosion.

– EBC recommends EBC Organic TT brake pads or for sporty drivers EBC sintered brake blocks in R or MXS mixture.

– Stand-alone design.

– The thickness of the brake disc may vary from the original part.